Go Back   Ducati Forum > Ducati Panigale Forum > Mechanical and Technical

Mechanical and Technical Mechanical and technical topics, help, and discussions

LinkBack Thread Tools Display Modes
Old May 14th 2012, 06:04 AM   #1
Senior Member
RepDucWayne's Avatar
Joined: Feb 2012
From: Maryland

Posts: 143
Thanks: 0

Are There Video on how to change track alignment from "Flat" to "Progressive"

Does anyone know of detailed video on how to set the bike from "flat" or "progressive" rideability?
RepDucWayne is offline  
Old Jun 11th 2012, 12:06 AM   #2
Senior Member
mrmaloo32's Avatar
Joined: Mar 2012
From: Australia

Posts: 244
Thanks: 3

I Ride: Full Custom Victory Hammer, Arlen Ness Victory Vision,2007 R1, Husaberg 570,Ducati 1199 S
or do i need to take to shop
someone should know how to explain this buy now
mrmaloo32 is offline  
Old Jun 12th 2012, 07:35 AM   #3
Joined: Apr 2012
From: France

Posts: 85
Thanks: 2

No vids as far as I know but this is the tutorial:

Moderately Easy:

1. You'll need to unload the swing arm:
a. Use a motorbike center lift or some similar
b. As I did:
I. Zip tie the front brake on
II. Locate some wood blocks or as I did ~ 17mm of high density foam to use as a center support
III. Position your support near the rear exhaust support (about under the Ducati of the clutch cover for a Termi setup)
IV. With the bike on the side stand, rock the bike over onto the side stand and front wheel till the rear is just clearing the floor
V. Slide in your supporting material

2. Remove the swing arm push rod pivot bolt (will need to support the rear wheel/swing arm a little to take the weight off the bolt - helps if you have an extra pair of hands)

3. Let the rear section go slack

4. Clear the swing arm push rod from the linkage assembly

5. Remove the swing arm push rod locking bolt

6. Screw out the push rod ball joint till the next alignment divot lines up with the locking bolt

7. Reinstall push rod locking bolt

8. Raise or pivot the bike to lower the swing arm and gain clearance to reinsert the swing arm push rod ball joint into the linkage assembly

9. Jiggle and support the rear wheel/swing arm till the swing arm push rod pivot bolt aligns with the forward hole on the linkage

10. Reinstall and tighten the swing arm push rod pivot bolt.
Valen75 is offline  

  Ducati Forum > Ducati Panigale Forum > Mechanical and Technical

alignment, change, flat, progressive, track, video

Thread Tools
Display Modes

Similar Discussions
Thread Thread Starter Forum Replies Last Post
1199 Panigali "Streetfighter" Sedici Ducati 1199 15 Jul 27th 2013 04:19 PM
“Aero kit” for the "S" pb0781 Ducati 1199 10 May 10th 2012 12:05 PM
When "did" you take delivery? USA only Mitchlguzin Ducati 1199 73 Apr 29th 2012 09:25 PM
1199 named "Most Beautiful Bike of Show" at EICMA duc Ducati 1199 1 Nov 14th 2011 03:49 PM

Facebook Twitter Google+ RSS Feed