CRG levers install problem

duckman · Oct 10, 2013

Ok, I am no ....... but I am having a hell of a time getting my brake plunger unscrewed from the stock lever without stripping the threads to install on the new CRG lever. Any tricks/tips?

Xbox · Oct 11, 2013

The bolt stem also threads into the lever housing, if that makes sense.

Hold the bolt firm with an allen key and loosen the nut off from the underside.

gnance · Oct 11, 2013

tap out the little metal dowel that is holding the part inside. You need to use a hammer and a pointed chisel or something. I don't think you can unscrew it far enough to release it....you need to take it a part at the joint held together by the little metal dowel.

S4bones · Oct 11, 2013

Little bolt

Iirc there is a little allen that holds the bolt in place. Make sure you take it out or you will destroy the threading.

flipper24196 · Oct 11, 2013

S4bones said:
Iirc there is a little allen that holds the bolt in place. Make sure you take it out or you will destroy the threading.

As the man said there is a tiny allen grub screw that needs to be backed off or you will wreck the threads.........

duckman · Oct 11, 2013

Thanks that is the problem.Success acheived!

S4bones said:
Iirc there is a little allen that holds the bolt in place. Make sure you take it out or you will destroy the threading.

CRG levers install problem

Help Support Ducati Forum:

duckman

Xbox

gnance

S4bones

flipper24196

duckman

Similar threads

Register CTA

Recent Discussions

Recent Discussions