Just wondering if I got a defective part or this is actually a common issue with DP parts.
I have a ducati performance Billet aluminium clutch casing cover 97380361A.
When I tried to install it, I noticed that the screw that comes with the kit does not fit straight through the holes of the cover due to the fact that the screws has a lip on them, and those lips will not allow the screw to go in straight towards the end of the tightening.
I ended up having to grind away a bit of the cover and around the screw to get it to fit right.
has anyone ran into the same issue? Is it common? Or did I just get lucky and got one that's not CNCed right?
I have a ducati performance Billet aluminium clutch casing cover 97380361A.
When I tried to install it, I noticed that the screw that comes with the kit does not fit straight through the holes of the cover due to the fact that the screws has a lip on them, and those lips will not allow the screw to go in straight towards the end of the tightening.
I ended up having to grind away a bit of the cover and around the screw to get it to fit right.
has anyone ran into the same issue? Is it common? Or did I just get lucky and got one that's not CNCed right?
