Termi slip on and Upmap

Ducati Forum

Help Support Ducati Forum:

Joined
Dec 23, 2022
Messages
5
Location
Newcastle
Hi all
I installed a termi slip on, to my '21 v4s and looking at the upmap they suggest disconnecting the lambda sensors.

Is this worthwhile doing, typically ive just put bike back together. Is it an easy job to do?

Thanks
 
Hi all
I installed a termi slip on, to my '21 v4s and looking at the upmap they suggest disconnecting the lambda sensors.

Is this worthwhile doing, typically ive just put bike back together. Is it an easy job to do?

Thanks

Fairly straightforward. I think one is under the tank, the other three easily accessible.
 
top tip if you are going to disconnect them make sure you blank the loom side away from earthing out. you can get proper connectors or just gaffer tape cover them....
the one at the front could either be around the ABS unit on the Off side or under behind the evap canister near the side stand connector on the nearside.
the rear cylinder one is a bit more of a bitch as you'll need to remove the tank to get at it.
 
top tip if you are going to disconnect them make sure you blank the loom side away from earthing out. you can get proper connectors or just gaffer tape cover them....
the one at the front could either be around the ABS unit on the Off side or under behind the evap canister near the side stand connector on the nearside.
the rear cylinder one is a bit more of a bitch as you'll need to remove the tank to get at
Cheers for the advice, was just planning on disconnecting the plug so I'll make sure to tape them up. Thanks mate
 

Register CTA

Register on Ducati Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Back
Top