What is this washer from the rear subframe?

CrazyBikerr · Jan 29, 2020

While doing the heatshield mod this washer fell off and now I can't figure out where it belongs to. I don't know if there is another that is stuck in the exhaust.

Clearly I didn't read the warning that the instructions came with. But I don't think that tank clamp nuts had or need washers on the 1299. Maybe 1199 has them.

KvalheimRacing · Jan 29, 2020

This washer is used several places, one of which is for the steering wheel damper nut. Check the website bikepartsducati or something, there you can see extruded part shemes

Sent from my HD1913 using Tapatalk

SickDuc · Jan 30, 2020

It’s the under side of the heat shield I believe. I’ll look for the diagram

Sent from my iPhone using Tapatalk

SickDuc · Jan 30, 2020

43 I was referring to

Sent from my iPhone using Tapatalk

SickDuc · Jan 30, 2020

My bad I don’t know how to edit post... not #43 but they are for that area, possibly for the bolts toward front of heat shield

CrazyBikerr · Jan 31, 2020

Thanks for looking. It's not that washer. The screw doesn't go through it.

SickDuc · Jan 31, 2020

No problem. I forget the exact spot but I know it goes in there somewhere because I had the exact problem when I changed my heat shield

Sent from my iPhone using Tapatalk

CrazyBikerr · Jan 31, 2020

SickDuc said:
No problem. I forget the exact spot but I know it goes in there somewhere because I had the exact problem when I changed my heat shield

Sent from my iPhone using Tapatalk

But then where did you put it back?

SickDuc · Jan 31, 2020

CrazyBikerr said:
But then where did you put it back?

I’d have to go look, I’ll check tomorrow

Sent from my iPhone using Tapatalk

razz · Feb 2, 2020

Did you have the side fairing panels off? There is one of those on each side right at the front. The long thin securing bolts from under the headlight goes through them. They usually stay in place as you take the panel off, then randomly fall out later when you knock the bike as you work on it.

CrazyBikerr · Feb 4, 2020

razz said:
Did you have the side fairing panels off? There is one of those on each side right at the front. The long thin securing bolts from under the headlight goes through them. They usually stay in place as you take the panel off, then randomly fall out later when you knock the bike as you work on it.

Good point. I will look as I couldn't find any screw to match these while working on the rear subframe.

CrazyBikerr · Feb 4, 2020

These are flat washers. The one I posted has a neck.

razz · Feb 4, 2020

Correct bolt, but the spacer goes between the red and the black panels. You cannot see it when the bike is assembled.

What is this washer from the rear subframe?

Help Support Ducati Forum:

CrazyBikerr

KvalheimRacing

SickDuc

SickDuc

SickDuc

CrazyBikerr

SickDuc

CrazyBikerr

SickDuc

razz

CrazyBikerr

CrazyBikerr

razz

Similar threads

Register CTA

Recent Discussions