fueling

When I first got the bike I noticed in first gear that rolling with a steady throttle just after the clutch bite point that fueling modulates itself like a rev-rev-rev sound. Almost like I'm reving the bike myself event though the throttle is held constant. Is this common? After 2800 stall...

Hi All, I have this odd issue to sort next week so I can compete at th first race of the season on the 16th: Engine stalled while accelerating out of a corner as if I had run out of fuel, which was confirmed not to be the case. Engine starts and runs fine with tank from my friend's 1199, but...

I posted in the 1299 thread also but figured I may get the answer here possibly. Does RB adapt to using other fuels besides 93, for example race fuel or e85? Sent from my iPhone using Tapatalk

Does rapidbike adjust/adapt for using race fuel or e85 or do I need to run a different tuning solution to take advantage of fuels other than 93? Sent from my iPhone using Tapatalk

Guys I have my 1299S Anniversario on order and I have been reading about a lot of low RPM fueling issues on the 1299's? Some are saying the bike is not being smooth and such and that a piggy back controller is needed? Are you guys seeing the same issue? I'm wondering if the new Anniversario...

Rode yesterday....290 miles..no issues... Today went for a shortish 100 mile ride..Right from the start something wasn't quite right... Pulled away from my garage and the bike kinda stumbled...like it was cold.... I thought Hmm..Odd never done that before but didn't think beyond...

Picked up a base, no abs, for racing the remainder of this season and for set up and prep for the next full season. I was amazed (and disappointed) on how much smoother the fuel delivery, throttle response, and performance is of the base over the Tri. And I'm talking about the tri with termi...

Anyone experience kinda not so sharp fueling during low rpms? Just got my bike yesterday and clocked abt 80km on them, the low rpm feels kinda bad =X Does it get better after running in or its a must to get a slip on + upmap or PC5 equivalent?