hose

I need a set of Samco hose clamps for the 1199 so that I can finish my 15,000-mile service and hit the track next weekend. Does anybody have a set to sell? Everyplace I have searched so far are out of stock or will not expedite shipping. (I know; right! Some "service.")

SAMCO Silicone Coolant Hose Kit: Ducati 899/959/1199/1299 Price: $222.95 FREE Shipping The Samco Sport hose kits are designed to replace original equipment in a wide range of performance vehicles, both in motorsport and fast road use. Superb integrity and superior performance reduces the...

Behind the ECU cover on my '12 1199 S. Noticed this hose is completely cracked/Leaking. I'm not too concerned because there's no gas or coolant - I'm assuming this is a crankcase vent or something. Anyone know?

I just finished a couple of repairs on the bike and now i can't figure out where this hose end up ? Please advise. (2012 1199 base)

Working on a different project (new signals) I saw this. Smells like fuel? Should be connected? Please assist all knowing ones...

Just wanted to share so everyone can point and laugh. Also, ample opportunity to once again scratch your head at Italian engineering. I'm so close...

While riding yesterday i noticed a thin stripe of dirt on the right upside of my steering damper. After further inspection i noticed the hoseclamp underneath the brakefluid-reservoir was pointing downwards, slightly touching the steering damper when putting the steer in maximum angle. This was...

the title may suggest a common occurrence but i'm not sure my sitch is. first time riding the Pani since removing the evap canister. filled up prior to heading out (did not overfill), rode 10 miles to my first destination....did not notice any drips at my first stop. went for a 80 mile...

Boys, Check ya radiator hose clamps. All 4 of mine were way loose. My bike has 1100kms and has just come back from its first service. Pull the left hand side faring off and get on them with a 7 mm. Mine were not touched since factory and were almost finger tight. I'm prety sure all of our...

Didn't find a thread for this yet so forgive me if it's redundant. Had some work done/dyno'd my Tri at Desmoto in SF. They've prepped a few 1199's for a couple local racers and one of the things they've learned is that the screw that holds the brake reservoir is long enough to cut into the...