psa

Putting on the spacers was one of the first things I did to my V4, on day two or so. Since then, I've put roughly 2700 miles on it and loved every second with very few issues. Today, leaving work, I went to turn on the bike and it threw a check engine light at me, struggled to start, and was...

All v4s owners, Ducati just released a few updates today. A few software ecu related and a couple gas purge valve hardware updates due to multiple reports of gas tank pressure. The ecu software update shuts down 2 cylinders at idle under 1800rpms, to reduce heat and also raises the idle rpm to...

Seems like MWR is up for something...

If anyone has put this on be careful. Rear brake line and traction control wires on my 1199 base were pinched and cut by the carbon fender. As the suspesion compresses while riding the lines flex and get caught rubbing the carbon fender edge. Luckily I noticed it before it was cut all the way...

So the weather was a little wet and I decided to take a few minutes and change the F to P on the rear linkage setting. Bike suspended properly and swing arm supported. Set screw removed as indicated. Whilst backing out swing arm adjusting bolt, it became a little tighter than it was...

Didn't find a thread for this yet so forgive me if it's redundant. Had some work done/dyno'd my Tri at Desmoto in SF. They've prepped a few 1199's for a couple local racers and one of the things they've learned is that the screw that holds the brake reservoir is long enough to cut into the...