1199 frame measurements

Hello all. I could use some help. I am building an 1199 trellis frame but I do not have a stock frame or motor (yet) to get measurements needed to start building a jig. I have attached a photo kinda showing the measurements I need.

I need the measurements between the mounting points on the motor, form the mounting point on the rear cylinder to the middle of the steering stem (there is a notch in the picture i circled), from the mounting point on the on the front cylinder to the middle of the steering stem (there a notch in the picture i circled).

Any help is greatly appreciated.

I am building a new bike that I can play on. I have a gsxr 750 but it does not put down the power the same a the Ducs I've ridden. A top of third slide on a duc is amazing!!! I have a bunch of duc parts sitting around that need to be on a bike. I was going to put them on the zx10r motor I have but that is going on ebay and will fund the 1199 motor I need for this project.

Thank you for the help

Abe

Already been done. A few times. You will need a bit of engineering data in addition standard structural analysis and you will of course need to build an air box. I would start here for data. Pierobon Frames

Thanks I appreciate your feedback. I saw theirs and still wanted to make my own