CAN bus resistor location - Christmas Tree Dash

Ducati Forum

Help Support Ducati Forum:

G

goodmatt78

Joined
Dec 2, 2021
Messages
7
Location
44709
Hello...this is a result of the Christmas Tree light issue on my 2013 Hyperstrada. I have my ECU, Dash and BBS at Carmo for the 2nd time (1st time didn't work). They have told me to check and replace the CAN bus resistors at the termination points....where are these? I don't see any resistors at the ECU, Dash or BBS plugs.....what am I missing or looking for?
 
On the Panigale, they're in the tail. It looks like a dummy plug with some heatshrink on it.

This is from a KTM, but I'm sure you'll get the general idea.

1733451838419.png
 
That's what I searched for but no luck and it doesn't appear on the wiring diagram either. I'll dig deeper this weekend and have the entire business by wire color.
 
The only place they appear on the Panigale is in the tail and near the ignition; where the heated grips plug into, should you buy them.

Do you know what error codes the bike is displaying?
 
My heated grips attach near the headlight. Error just says can bus error, but I have bigger issues being the spikes from the beru ignition coils fried my ECU. I got that fixed but it still work. I was told to check the termination resistors.

I guess I can just check resistance at the diag plug and if it's 60 ohms, they should be good.
 

Similar threads

F
Panigale V4S DQS custom fix
Replies
0
Views
480
Fulcrum
F
R
ECU specification
Replies
0
Views
234
Raidoctober
R
Helo AP
2023 V4 Dash replacement/ dealership cannot program
Replies
7
Views
403
Helo AP
Helo AP
J
Panigale V2 Pops and backfires with Arrow Exhaust Slip
Replies
9
Views
721
Shazaam!
S
W
hyper motard electrical gremlins
Replies
3
Views
539
Sydneyhyper
S

Register CTA

Register on Ducati Forum! This sidebar will go away, and you will see fewer ads.

Recent Discussions

Back
Top