Paddock stand
- Thread starter Gregw
- Start date
Help Support Ducati Forum:
- Joined
- Feb 28, 2020
- Messages
- 54
- Location
- Shrewsbury, UK
Rear wheel axle nut size is 55mm. The paddock stand pin size is 40mm
www.rg-racing.com
Single Sided Paddock Stand Pin - 40.0mm OD
www.rg-racing.com
- Joined
- Feb 28, 2020
- Messages
- 54
- Location
- Shrewsbury, UK
Are you in the UK Gregw? I have a 55mm socket that I could post to you, its no use to me as I cant loosen, or tighten the nut on my own. I purchased it and cant use it due to the torque involved
Last edited:
In Adelaide South Australia
- Joined
- Feb 28, 2020
- Messages
- 54
- Location
- Shrewsbury, UK
I reckon that would cost me more in postage than the socket is worth as its quite heavy. Anyway, keep safe mate and throw another shrimp on the barbie
Thanks for the offer, really nice of you, purchased the socket anyway, unsure whether I will use it, but handy to have anyway...
- Joined
- Feb 28, 2020
- Messages
- 54
- Location
- Shrewsbury, UK
No worries mate. Yeah its a handy bit of kit to have in the toolbox. I think id need to invest in an air compressor and a windy gun to use it though as my electric impact wrench isnt up to the 240 ft/lb of torque to get that nut loosened
Similar threads
Register CTA
Register on Ducati Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
