Rear Axle Sliders by CNC Racing - DOES NOT FIT!!! help!

Ducati Forum

Help Support Ducati Forum:

Joined
Aug 8, 2013
Messages
67
Location
Montreal
Rear Axle Sliders by CNC Racing - DOES NOT FIT!?!

Hello,

I have an issue with the rear slider by CNC Racing I rencently ordered (TP424R For Panigale)... They DO NOT FIT on my Ducati 1199 Panigale (Base model). The cup fits on the right side but not on the left near the sproket... The transversal bar is a tiny bit too long as well so overall it's impossible to fit.

Does anyone have the same issue??? Unfortunately I have thrown away the box so I can't confirm 100% that I received the right model (TP424)...

Please share your experience with this product! How easy was it to install?

Thanks folks!

TP424_lg.jpg
 
Last edited:
I have them on my bike. Make sure you have the correct plastic cup on each side (Left and right) they are not the same size. a little effort is required to put them on. The bar should be a tad long and fit through the plastics cups. I removed the retaining washer as they are a pain in the ass. I also notched the plastic where the wheel/sprocket nut retaining pin interfers.
 
I ended up physically modifying the parts to make them fit!!! I do not know if the parts I received were right or not but I had to sand the interior of the left cap, and remove the retainer rings on each side of the transversal bar in order for this whole thing to fit"¦ Not sure what to think of all this but just sharing information. :(
 


Write your reply...

Register CTA

Register on Ducati Forum! This sidebar will go away, and you will see fewer ads.
Back
Top