Rear break light switch after installing rearsets

jmparton · Jul 8, 2013

I just installed a set of Lightech rearsets and do not plan on using the rear break light. I noticed the switch for the rear break light needs to be depressed. Anyone know of a easy way to do this? It seems simple enough if I could find a closed nut to cap it off, however, efforts so far have not resulted in any luck.

lardawge · Jul 8, 2013

Follow the wire up to the connector and unplug at the connector.

AntiHero · Jul 8, 2013

lardawge is right....just need to unplug the switch after following it upwards. It's on the right side under the black plastic cover, just have to remove the right side fairing.

YearOne · Jul 9, 2013

I only noticed this out riding and used a small stone inside a tyre valve cap which screws onto the thread of the switch. Bit ghetto but works well.

AntiHero · Jul 9, 2013

Nice, YearOne! Ghetto, but genius.

Phl · Jul 9, 2013

I just taped it and secured the tape with a zip tie. holds well ever since.

mig1199 · Jul 10, 2013

YearOne said:
I only noticed this out riding and used a small stone inside a tyre valve cap which screws onto the thread of the switch. Bit ghetto but works well.

Neat Idea...

Rear break light switch after installing rearsets

Help Support Ducati Forum:

jmparton

lardawge

AntiHero

YearOne

AntiHero

Phl

Moderator

mig1199

Similar threads

Register CTA

Recent Discussions