light

So I just got the bike repaired after endoing it almost two months ago. Looks great, get it done at 10 P.M. and load the truck up. Roll to the track, get there midnight and wake up at 6. All excited, go for my outlap and 50 feet into it I realize the bike won't rev past 6k. Bike putters for the...

Anyone know what the "Stop Light" warning light means? I just put on the CW fender eliminator and the warning light came on for a few seconds when the key is on but engine not running. The bike still runs just fine, I just get the warning "Stop Light" when the engine is not running but key on...

Thinking of installing the CW Integrated tail light kit (Smoke). Does anyone know if its really "plug and Play"? How difficult is it to remove the stock light and install CW's in its place? Any instructions on how to remove or install would be great. or should I let the stealer (I mean...

So finished my body work today and go for a test ride when I notice the light is on after start up. It wasn't before and all I disconnected has headlights, taillights, turn signals. I have the plug in for the kickstand. Can any of these for some strange reason cause a check engine light??

>To all my fellow members with a full exhaust or knowledge about the Panigale computer/wiring system: I have finally finished the excruciating Full Akrapovic system install on my Panigale 899 along with my magnesium case cover, Ducabike clear clutch cover, Oil change, Charcoal canister...

While the issue I am posting about is seemingly well known on the 1199, I am posting a new thread for the added SEO benefits for the guys (or gals) that will inevitably have this issue with their 2015 1299 Panigale. 2015 Ducati 1299 Panigale CAN LINE Internal Sensor Check Engine Light Error ABS...

All my previous riding was in the UK where it was perfectly acceptable to filter to the front of traffic stopped at a traffic signal by lane splitting up the middle of a dual carriageway. Whilst I generally sit in traffic during my commute there have been occasions where I have needed to get...

Went to go for a ride today and the bike won't start. It comes on, but the bid red box appears and says ABS!. It won't allow the bike to start. I checked the connections and everything seems fine. Bike rode great yesterday. Any ideas??

Ohlins Steering Dampner $225.00 Full set fairings and Light kit. Rode on street for 1500 miles. $1400(make me an Offer)

Hey guys my brake light is stuck on. I've recently put on a fender kit and new Ducabike levers. I checked my rear plug and it's good. Manually pushed in both rear and front brake switches. Nothing will turn brake light off. Is it common for a switch to go bad?

Going over my bike after riding today and noticed I've got four small cracks from stones in my tail light...two each side! When you have a closer look it is peppered with stone chips. Might pay to put some clear plastic film over it. Anyone else come across this or is it just the .... roads I...

I don't think I saw anyone announce it yet but for those who have been patiently waiting for Motodynamic to finally release their Panigale tail light, they posted a video and some additional information on it AND the price is still the same... so far... So hopefully we'll see the release of it...

Full set of fairings and Light kit. Rode on street for 1500 miles. $1500.00 (make me an Offer) Also includes kickstand and rear light. Ohlins Steering Dampner $225.00 bump

Filled up gas tank, (maybe too much) engine light is on now. I know it could be anything but some insight could be helpful :):) Thanks in advance

Has anyone used one of these to reset the service indicator? Electrical / Ignition | Products | ca-cycleworks.com The website says the correct model is the Centurion-S-Siemens is the correct version for the 1199, but I wonder about that because the 1199 has Mitsu ECUs not Siemens ones.

For those of you that use track body work and remove the rear tail lights this is the connector to unplug so no errors are displayed. Right hand side of bike Disconnected

so i took my bike out of the garage today turned the key and "STOP LIGHT!" popped up on the dash, and also a yellow symbol of a motor on the right side of the dash. I googled what the STOP LIGHT meant and it said something about loose wiring for my brake lights. So, i popped the trunk and played...

Posting for a friend who is just now experiencing this problem with his 2014 899: "Check engine light comes on. .. bike just shuts off. I turn it off and restart and it runs fine for about 20 seconds then repeats. Ever heard this issue?"

Was re-assembling the controls today and wanted some help. On the clutch master cylinder micro-switch there is a small metal arm on the switch itself that presses onto a rubber nipple behind but on the front brake it just has a small rubber nipple and no arm in front of it. Could someone please...

I've currently got an engine warning light and the bike isn't running as it should, spluttering badly once under load. It otherwise runs fine. The error light goes out on turning the bike off and comes on again when coming on load, if I dont ask for power then it seems to stay off for a while...