Front axle

FlyingMonkey said:

I over torqued my pinch bolts once…… ONCE! I’ll never do it again.
I still can’t believe how easy the axle obliged and how expensive a replacement is.

Click to expand...

steve2z said:

Replaced the bearings on my front wheel and the axle was a pain to get out, and is a pain to get back in- it shouldn’t be a hammer fest right? I’m thinking axle is slightly enough bent and that’s causing the fitment issue. Just looking for verification- thank you all!

Steve

Click to expand...

1. Slightly Bent Axle – Even a small bend can cause significant resistance. Roll it on a flat surface (like glass or a granite countertop) to check for wobbling.
2. Misaligned Forks – If the forks are not perfectly aligned, they can create binding. Try loosening the fork pinch bolts and the lower triple clamp, then realign before tightening.
3. New Bearings Not Seated Properly – If the new bearings are slightly misaligned or not fully seated, they can alter the spacing.
4. Axle or Fork Tube Corrosion/Debris – Even minor dirt, corrosion, or burrs on the axle or inside the wheel hub can cause interference. Clean everything thoroughly and lightly grease the axle.
5. Spacer Issue – If the internal wheel spacer shifted during the bearing replacement, it might not be lining up properly.

• Check Axle Straightness: Roll it on a flat surface to see if it's bent.
• Inspect Fork Alignment: Loosen the fork pinch bolts, insert the axle (without forcing it), and see if it slides in easier before tightening everything back up.
• Ensure Bearings Are Fully Seated: Double-check that they’re pressed in correctly and flush.
• Clean & Lubricate: Clean the axle and apply a thin coat of grease to help smooth insertion.
• Check the Wheel Spacer: Make sure it’s properly in place and hasn’t shifted.