Front axle

Ducati Forum

Help Support Ducati Forum:

Joined
Sep 7, 2022
Messages
13
Location
Corning NY USA
Replaced the bearings on my front wheel and the axle was a pain to get out, and is a pain to get back in- it shouldn’t be a hammer fest right? I’m thinking axle is slightly enough bent and that’s causing the fitment issue. Just looking for verification- thank you all!

Steve
 
Was it hard to get out before you changed the bearings ? Definitely loosened the pinch bolts on bottoms of forks yeah ?
 
Pinches loosened and yes harder to get out then I would have expected- hammer and big punch to drive it out
 
I over torqued my pinch bolts once…… ONCE! I’ll never do it again.
I still can’t believe how easy the axle obliged and how expensive a replacement is.
Yep, just submitted an offer on ebay for a used one- 100$

He nicely accepted my offer so I do have another coming- but am going to pull the current one(or more accurately pound it back out and measure the bend.
 
Last edited:
Replaced the bearings on my front wheel and the axle was a pain to get out, and is a pain to get back in- it shouldn’t be a hammer fest right? I’m thinking axle is slightly enough bent and that’s causing the fitment issue. Just looking for verification- thank you all!

Steve

You're absolutely right—it shouldnt be a hammer fest to get the front axle in and out on your bike. The axle should slide in smoothly with minimal resistance, typically requiring only gentle persuasion.

Possible Causes of Your Issue:
  1. Slightly Bent Axle – Even a small bend can cause significant resistance. Roll it on a flat surface (like glass or a granite countertop) to check for wobbling.
  2. Misaligned Forks – If the forks are not perfectly aligned, they can create binding. Try loosening the fork pinch bolts and the lower triple clamp, then realign before tightening.
  3. New Bearings Not Seated Properly – If the new bearings are slightly misaligned or not fully seated, they can alter the spacing.
  4. Axle or Fork Tube Corrosion/Debris – Even minor dirt, corrosion, or burrs on the axle or inside the wheel hub can cause interference. Clean everything thoroughly and lightly grease the axle.
  5. Spacer Issue – If the internal wheel spacer shifted during the bearing replacement, it might not be lining up properly.
What to Do:
  • Check Axle Straightness: Roll it on a flat surface to see if it's bent.
  • Inspect Fork Alignment: Loosen the fork pinch bolts, insert the axle (without forcing it), and see if it slides in easier before tightening everything back up.
  • Ensure Bearings Are Fully Seated: Double-check that they’re pressed in correctly and flush.
  • Clean & Lubricate: Clean the axle and apply a thin coat of grease to help smooth insertion.
  • Check the Wheel Spacer: Make sure it’s properly in place and hasn’t shifted.

If you confirm the axle is bent, replacing it is the safest option. Let me know if you need help troubleshooting further!
 

Register CTA

Register on Ducati Forum! This sidebar will go away, and you will see fewer ads.
Back
Top