About a year ago I bought a T800 dongle and the Mtorque map. I had no issue installing. However I plugged in the dongle today and got a notification of an update. I clicked GO and got an error message - my VIN does not exit.... See below. Anyone had the same issue?? Regards!
View attachment 39761
Thanks! It does not allow me past the error message! Regards!Mine did the same, last week on my Hyper. I clicked OK, it updated the T800 firmware, I unplugged from the bike(key off), plugged back in, turned on bike and all was good.
I've uploaded two maps since it happened.
Mtorque removes the power limits in the first 4 gears. I think it’s just a throttle position limit.
Well, it updated the original Mtorque map last night (took about 10 min.).... In your opinion, what does it do??The device firmware has nothing to do with a Mtorque map.
This has got nothing to do with the T800... I got the error sorted after I contacted UPmap and was told to run a procedure that eventually worked and it did an UPDATE on the MAP (Mtorque) I bought from them about a year ago... Plug in your T800 and see if it indicates an update."Read back in the thread" like you're going to give me a task.
I was trying to walk him onto a terminology correction. There isn't a Mtorque T-800 firmware update. Mtorque is a type of map which isn't the same as device firmware for the T-800.
He's having an issue with a firmware update, not a Mtorque map.
"Read back in the thread" like you're going to give me a task.
I was trying to walk him onto a terminology correction. There isn't a Mtorque T-800 firmware update. Mtorque is a type of map which isn't the same as device firmware for the T-800.
He's having an issue with a firmware update, not a Mtorque map.
A little off topic, has anyone removed the lambda sensors after installing the Upmap? I’ve read in the FB group that it’s a requirement as they can still read data and conflict with the Upmap.