Anybody with TuneBoy loaded the Dyno Tune?

TuneBoy V6 tunes come with a map that is a 1299 Dyno tune, anyone tried it?

Cheers

When I spoke to Wayne I said "There two files that sound like they are for a stock bike: "pani1299_zerotrim_v6" and "pani_STD_exhaust_TB_Dyno_v6" I am thinking I should run the latter?

wayne replied "Yes, the latter is the one I did on our Dyno. This was a completely standard bike."

I am running the dyno file and the bike is no longer unexpectedly dying at low RPMs which is great. It also disables the clutch switch in 1st gear so its easier to modulate the clutch from a stop. The bike seems to have more power off idle which is all I cared about (trying to increase street driveability, don't care about power). Although I have noticed after sitting at a stop for awhile, when the bike gets hot it doesn't seem to have as much power off idle which makes it hard to get going from a stop.

I am thinking the "zerotrim" file would restore the bike to stock? I haven't messed with the tuneboy in a few months though so I forget how it all works..

OK, thanks for that information, I'll give it a go and see what happens. I have the standard (probably zero trim) loaded at the moment and it too cured the low RPM problems.

Cheers

Good to know there's a difference between that file and stock. I may have to try that one and see the difference.

Loaded the dyno tune but it has a small hesitation just off of idle, when properly warmed up. I think this is what you experienced as well.