Ducabike Handelbar raisers SF4VS

Miltos · May 22, 2022

Hello everyone,

Yesterday I installed those handlebar raisers (20mm higher) on my SF4VS. The riding feels more upright and more comfortable so far. HOWEVER, I do not know, with the addition of those spacers, what kind of implications could these have on handling

Any thoughts?

Thank you in advance for your responses.

Alkhater · May 25, 2022

Theoretically no difference in handling but a miniscule difference in leverage.

Maybe you can test ride and give us your impressions?

Miltos · Jun 1, 2022

So I have driven about 50 km. Its definitely more comfortable on the highway and the riding seems more upright. It seems that there is an improvement in terms of comfort. I would recommend it.
I do not know how handling is affected though or how it behaves in high speeds compared to the stock. I do not think it makes a huge difference for normal driving. Aesthetically the difference is minor however you can see the stock mirrors sticking out like "ears"(might be my impression). So far good impressions.

Hok · Aug 2, 2022

Wires and cables all ok? full turned tested?

Thanks

Miltos · Aug 3, 2022

It is only 2cm, which it's not a huge difference in order to have an impact on the cables. No problem at all.

Tuckerhauser · May 14, 2023

Afternoon,
Just purchased these myself and I'm struggling to find torque specs for the 2 bolts that go thru the risers.
Do u have the torque specs?

Thanks

mannysfv4s · May 17, 2023

Tuckerhauser said:
Afternoon,
Just purchased these myself and I'm struggling to find torque specs for the 2 bolts that go thru the risers.
Do u have the torque specs?

Thanks

20-25 nm on stock risers

MrBikeBits · Jun 9, 2023

I too cannot find the torque values for the 2 bolts that go through the risers into the triple clamp. I believe the handlebar clamps are 25nm with the backside being closed first. Anyone have an idea on the torque specs? Mine are just "tight" for now

mannysfv4s · Jun 9, 2023

MrBikeBits said:
I too cannot find the torque values for the 2 bolts that go through the risers into the triple clamp. I believe the handlebar clamps are 25nm with the backside being closed first. Anyone have an idea on the torque specs? Mine are just "tight" for now

Not more than 25nm

MrBikeBits · Jun 9, 2023

I managed to find the Ducabike instructions (attached). 48nm for the 2 mounting screws

mannysfv4s · Jun 9, 2023

MrBikeBits said:
I managed to find the Ducabike instructions (attached). 48nm for the 2 mounting screws

My bad I meant 20-25 nm for clamp bolts

Ducabike Handelbar raisers SF4VS

Help Support Ducati Forum:

Miltos

Alkhater

Miltos

Hok

Miltos

Tuckerhauser

mannysfv4s

MrBikeBits

Attachments

mannysfv4s

MrBikeBits

Attachments

mannysfv4s

Similar threads

Register CTA

Recent Discussions