Best kit for 1199 engine rebuild and what sites?

I'll post a list of part numbers later however the bearings will be specific to each application. You can determine this be the letter codes and validate with measuring bearing gap clearances.

Seth Vo said:

Unfortunately no. I've rebuilt many other motors before so knew the basics and then spent a good deal of time researching and speaking to the small group of ducati engine building for guidance.

Every situation is different depending on what your doing but once you know what you need it's just ordering from Ducati directly.

There are a few companies like Athena that make aftermarket gasket kits but I just stayed with the OEM Ducati parts.

Click to expand...

Do you have any builders around the Northeast that you recommend?

Seth Vo said:

I'll post a list of part numbers later however the bearings will be specific to each application. You can determine this be the letter codes and validate with measuring bearing gap clearances.

Click to expand...

Here's a good list to start with:

• 79120531B Liner gasket rings (need 2 sets)
• Head gasket 78611212c (need 2 gaskets)
• Oil filter 44440312B (need 1)
• Rod bolts 77916192c (need 4 bolts total as one time use)
• Piston rings 12120561B (2 sets)
• O ring for oil pick up 88641331A
• Oil pick-up assembly 89420113B
• O ring clutch cover 88641761A
• Con-rod bearings x 4 (measure and compare to code chart)
• Main bearings x 4 (measure and compare to code chart)
• Case green O ring 88641701a
• Long head bolts 76610781a (8)
• Short head bolts 76610801a (2)
• Long head bolts dowls 71110932a
• Piston pin circlip 121126041B (4)

I also was planning on replacing the water pump plastic gear with the steel version.

rja4z3 said:

Do you have any builders around the Northeast that you recommend?

Click to expand...

Where are you located? I'm near Detroit. Duc Shop ship in Georgia and Boulder Motorsports in Colorado are good.

Depends what your doing but in general I would say it's cheaper to swap another motor versus the rebuild unless you enjoy it like I do or want to keep the original motor. The OEM parts are about $1500 and you'll have $2k in labor on average and that's with the motor removed and that's just a base rebuild. You can get decent used ones for $3k so it's really up to you on what you want to do with it. I like to do it myself and no one will take the time to balance the parts and check every clearance and that's the best way to do it.

Where are you guys finding these motors i need a 1199 motor my 2014 motor is sadly no good

ducati culture said:

Where are you guys finding these motors i need a 1199 motor my 2014 motor is sadly no good

Click to expand...

I've got 3, and me a message and let me know where your located

Do you plan on re-using the piston and valves?

elements018 said:

Do you plan on re-using the piston and valves?

Click to expand...

Valves no but I've got a full rototating assembly for the 1199 I am not using if you need (crankshaft, rods, pistons). Messgaes me if needed

Hi Seth, have you sold your crankshaft, rods and pistons? Do you have the pistons sleeves as well?

I do still have some parts for 1199 and 1299 engines, just depends on your situation and what you are looking for. Send me a DM to discuss further.