Recently installed a SC Project CR-T exhaust on to my 2024 streetfighter V4. I did the upmap ecu flash for that specific exhaust but noticed that the throttle response is very choppy / studders at low rpm. On one occasion the bike got a check engine light p061A “ internal control module torque performance”. I was able to clear the code but it recently did it again at around 3k rpm. Anyone have insight on what could be going wrong?
Streetfighter V4 2024 SC Project Upmap Issues
- Thread starter Conman
- Start date
Help Support Ducati Forum:
- Joined
- Oct 27, 2013
- Messages
- 308
- Location
- Salem, Germany
This means that the airflow maps are improperly tuned with the Termi Upmap and the torque monitoring diagnostics are triggered. I would not recommend continuing to run this map.
What do you recommend? I have the same issue with my 2021 SFV4s.
Definitely would make sense. I reached out to Upmap to see if they have any explanation as the map is advertised for that specific bike and exhaust setup. Would a brentune be better suited?
I agree with the cheap map. What would you recommend in terms of getting the correct mapping for an exhaust like that?
- Joined
- Aug 14, 2024
- Messages
- 40
- Location
- Clearwater, FL
You have a reply above from Deussen. Both themselves and Shiv at OFT provide excellent service and results. I haven't used them but BT seems rougher around the edges and some say good and some say bad about them. The thing is, the Deussen tunes are sophisticated. That is what it takes to handle a multi-layered problem like tuning a V4. It takes actual expertise. Deussen or OFT.
Register CTA
Register on Ducati Forum! This sidebar will go away, and you will see fewer ads.
Sign Up
